Frigidaire FGGS3045KW Instructions D'installation page 3

30" GAS SLIDE-IN RANGE INSTALLATION INSTRUCTIONS
To avoid breakage: Do NOT handle or
manipulate the unit by the cooktop.
The counter-top around the cut-out should be flat and leveled
1
(see hatched area on illustration 1).
Before installing the unit, measure the heights of the two (2) cabi-
2
net sides (H1-4), front and back (see illustration 1) from the floor
to the top of the counter.
Level the range using the
four (4) leveling legs, so
that the height from the
floor to the underside of
3
the metal flange is greater
than the tallest cabinet
measurement by at least
1/16" (see illustration 2).
Slide the unit into the cabinet. Make sure the center of the unit is
4
aligned with the center of the cabinet cut-out.
Remove the protective channels on each side of the cooktop
5
(if provided).
The metal flange under each side of the cooktop MUST be placed
over the cabinet countertop for proper unit support. The cooktop
6
should NOT rest directly on the countertop (see illustration 2) or else
it could cause damage to the cooktop voiding the warranty. Level the
unit if needed.
After the installation, MAKE SURE that
7
the unit is supported by the two front
leveling legs and the two adjustable
leveling wheels
and NOT by the
cooktop.
1 ½" Max.
Shave
(3.8 cm Max.)
Raised
Edge
to Clear
Space for a
31½" (81 cm)
Wide Cooktop.
3
Illustration 1
To successfully
install the range,
the initial level
height from floor
to underside of
cooktop frame
should be at least
1/16" taller than
cabinet sides as
measured in step
2.
Illustration 2