Equipotential; Start-Up; Instructions For Use; Ignition - Lotus SA-400 Instructions Pour L'installation Et L'emploi

The appliance must be connected to an equipotential system. The connection screw is positioned on the rear part of the
appliance and is distinguished by the symbol
Warning: The manufacturer is not responsible and does not give compensation under guarantee for any damage due to
installations that are inadequate and that are not in accordance with the instructions.
Check the connection of the appliance and then start it following the instructions.
N.B.: For releasing the trolley of mod. SL-600, unscrew the 2 fixing screws on the back.
Warning: Never leave the working appliance unattended!
The salamanders are appliances for gratinating, grilling and heating dishes.
This appliance shall be used exclusively for the purpose for which it was designed. Any other use shall be considered
improper and therefore dangerous.
GB IE

EQUIPOTENTIAL

.

START-UP

INSTRUCTIONS FOR USE

Turn on the main switch and rotate the temperature
adjustment knob clockwise from position 0 to the desired
temperature between 1 and 6. The resistors are made up of
two independently operating elements, each of which has
its own control knob. Control knob (A) operates the left
resistor and control knob (C) operates the right resistor.
Indicator light (B) indicates that the left resistor is on, and
indicator light (D) indicates that the right resistor is on.
Each time the temperature falls below the set value, the
regulators automaticaly turn on the corresponding resistor.
When the regulator is in the maximum temperature
position, the resistors are always on.
After using the appliance, rotate the knob to the "0"
position and disconnect the appliance from the mains.
22

IGNITION