Connection To The Audio System; Mains Connection - Conrad CDX-10 Notice D'emploi

All manuals and user guides at all-guides.com

8. Connection to the audio system

The CD player has Cinch sockets AUDIO OUT (26) for connection to your audio system (e.g. mixing desk).
For connecting the outputs, use only shielded cables. The use of other cables might cause
interference.
To avoid distortion or mismatching that could damage the device, only devices with the same
connections may be connected to the various connections.
For this, observe also the connection data in the section "Technical Data".
• Connect the sockets AUDIO OUT (26) with the CD inputs of your mixing desk or pre-amplifier.
• Connect the socket „L" with the left input and the socket „R" with the right input.

9. Mains Connection

The mains outlets to which the CD player is connected must be easily accessible to quickly
separate the device from the mains voltage in case of an error.
Ensure that the voltage selector switch (23) is in the correct position for your supply voltage.
The CD player and all connected devices must be turned off when connecting the voltage
supply.
Ensure that all the electrical connections and connection cables between the different devices
and any extension cables comply with the regulations and comply with the operating instructions.
• Connect the small device connection plug of the power line to the mains connection AC IN (27) on the device.
• Plug the power plug of the power supply cable into a wall socket.
• The POWER switch (24) is used to switch the CD player on and off (ON: appliance is switched on, OFF: the
appliance is switched off).
34