Publicité
Les langues disponibles
Les langues disponibles
All manuals and user guides at all-guides.com
If you use a key to store a macro on which a macro is already stored, it
will be overwritten.
The original function of a key is deleted when a macro is stored on it.
No already existing macro cannot be integrated in a macro command
series. If, in programming macro sequence, a key is pressed on which a
macro is already stored, this will be ignored.
If you would like to integrate the recording function for a video recorder
into a macro, you have to keep the recording key 2 down for 2 seconds.
This is used to prevent accidental deleting of video cassettes.
Triggering macro commands
•
Press the device selection key (5) on the operating key area of which you have
stored the macro.
•
Direct the universal remote control towards the devices to be controlled.
•
Press the control key (4) on which you stored the macro.
•
The stored commands will be executed in the order they were programmed.
In order to restore the original function of a key which a macro was saved
on, you can delete the macro by deleting the function of the key, as
described under „Deleting a key" above in these instructions.
While the macro is run, you can stop the sequence of commands any time
by pressing the EXIT key. In this case, ERROR is displayed and the
macro stopped.
Checking macro keys
This function shows you what keys of this device a macro has already been saved.
•
Press the device selection key (5) of the device to be checked.
•
Press the MACRO key.
•
As long as the MACRO key is pressed, only those keys are displayed which a
macro was saved on.
56
Operating Instructions
English
Publicité
