Publicité
FEDERAL COMMUNICATIONS COMMISSION (FCC) & INDUSTRY CANADA (IC) STATEMENTS
The user shall not make any changes or modifications to the equipment unless authorized by the Installation Instructions or User's Manual. Unauthorized changes or modifications could
void the user's authority to operate the equipment.
CLASS B DIGITAL DEVICE STATEMENT
This equipment has been tested to FCC requirements and has been found acceptable for use. The FCC requires the following statement for your information:
This equipment generates and uses radio frequency energy and if not installed and used properly, that is, in strict accordance with the manufacturer's instructions, may cause interference
to radio and television reception. It has been type tested and found to comply with the limits for a Class B computing device in accordance with the specifications in Part 15 of FCC Rules,
which are designed to provide reasonable protection against such interference in a residential installation. However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
•
If using an indoor antenna, replace it with a quality outdoor antenna.
•
Reorient the receiving antenna until interference is reduced or eliminated.
•
Move the radio or television receiver away from the receiver/control.
•
Move the antenna leads away from any wire runs to the receiver/control.
•
Plug the receiver/control into a different outlet so that it and the radio or television receiver are on different branch circuits.
•
Consult the dealer or an experienced radio/TV technician for help.
INDUSTRY CANADA CLASS B STATEMENT
This Class B digital apparatus complies with Canadian ICES-003.
Cet appareil numérique de la classe B est conforme à la norme NMB-003 du Canada.
FCC / IC STATEMENT
This device complies with Part 15 of the FCC Rules, and Industry Canada's license-exempt RSSs. Operation is subject to the following two conditions: (1) This device may not cause
harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation.
Cet appareil est conforme à la partie 15 des règles de la FCC et exempt de licence RSS d'Industrie Canada. Son fonctionnement est soumis aux conditions suivantes: (1) Cet appareil ne
doit pas causer d'interférences nuisibles. (2) Cet appareil doit accepter toute interférence reçue y compris les interférences causant une réception indésirable.
Responsible Party / Issuer of Supplier's Declaration of Conformity: Ademco Inc., a
subsidiary of Resideo Technologies, Inc., 2 Corporate Center Drive., Melville, NY 11747,
Ph: 516-577-2000
Warning – The antenna(s) used for this device must be installed to provide a separation distance of at least 7.8 inches (20 cm) from all persons and must not be co-located or operating in conjunction
with any other antenna or transmitter except in accordance with FCC and ISED multi-transmitter product procedures.
Exposition aux Fréquences Radio: La/les antenne(s) utilisée(s) pour cet émetteur doit/doivent être installée(s) à une distance de séparation d'au moins 20 cm (7,8 pouces) de toute personne et ne
pas être située(s) ni fonctionner parallèlement à tout autre transmetteur ou antenne, excepté en conformité avec les procédures de produit multi transmetteur FCC et ISED.
The product should not be disposed of with other household waste. Check
for the nearest authorized collection centers or authorized recyclers. The
correct disposal of end-of-life equipment will help prevent potential negative
consequences for the environment and human health.
Any attempt to reverse-engineer this device by decoding proprietary
protocols, de-compiling firmware, or any similar actions is strictly
prohibited.
The Honeywell Home Trademark is used under
license from Honeywell International Inc.
La Honeywell Home est une marque de commerce
de Honeywell International inc. utilisée sous licence
par Resideo Technologies, inc.
Partie responsable / Émetteur de la déclaration de conformité du fournisseur : Ademco Inc., une
filiale de Resideo Technologies, Inc., 2 Corporate Center Drive., Melville, NY 11747, Tél. 516 577-
2000
RF EXPOSURE
Mise en Garde
Support and Warranty / Soutien et Garantie
For online support information, please go to:
Pour de l'assistance en ligne, visitez : www.resideo.com
For the latest warranty information, go to:
Pour les dernières informations de garantie, s'il vous plaît aller à :
https://www.security.honeywellhome.com/warranty
For patent information, see:
Pour des informations sur les brevets, voir www.resideo.com
This product manufactured by Resideo and its affiliates.
2 Corporate Center Drive, Suite 100
P.O. Box 9040, Melville, NY 11747
2020 Resideo Technologies, Inc.
www.resideo.com
Ce produit ne doit pas être jeté avec les ordures ménagères. Recherchez
les centres de collecte ou de recyclage autorisés les plus près de chez
vous. L'élimination adéquate d'équipement en fin de vie permet d'éviter les
conséquences néfastes sur l'environnement et sur la santé humaine.
Toute tentative d'ingénierie inverse de cet appareil,en décodant les
protocoles propriétaires, en décompilant le logiciel microprogramme ou en
effectuant toute mesure similaire est strictement interdite.
Ê800-22573V1COŠ
800-22573V1C 12/18 Rev C
Publicité
