Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Liens rapides
C7089U Outdoor Sensor
USE WITH TH8000 THERMOSTATS OR OTHER
COMPATIBLE RESIDEO CONTROLS
READ BEFORE INSTALLING
APPLICATION
The C7089U Outdoor Sensor is compatible with
certain Resideo thermostats and controllers, such as
the THX9421R Prestige thermostat with EIM, TH8000
series RedLINK and Wi-Fi thermostats, TH7000
series thermostat, TH6220U and TH6320U models of
the T6 Pro series thermostats, TH6220WF and
TH6320WF models of the T6 Wi-Fi series
thermostats, the HZ432 zone panel, and the H6062
HumidiPRO controller.
SPECIFICATIONS
Operating Ambient Temperature Range:
-40 to 120 °F (-40 to 49 °C).
Display Range:
-40 to 127 °F (-40 to 53 °C).
Sensor Accuracy:
+/-1.5 °F at 70 °F (+/-.84 °C at 21 °C)
Operating Relative Humidity:
5% to 95% non-condensing.
Dimensions in in. (mm):
2-1/4 (57) x 3/8 (10) with 60 (1524) leadwires.
INSTALLATION
When Installing this Product...
1. Read these instructions carefully. Failure to
follow them could damage the product or cause
a hazardous condition.
2. Check the ratings given in the instructions and
on the product to make sure the product is
suitable for your application.
INSTALLATION INSTRUCTIONS
3. Installer must be a trained, experienced service
technician.
4. After installation is complete, check out product
operation as provided in these instructions.
CAUTION
Electrical Shock Hazard.
Can cause electrical shock or equipment
damage.
Disconnect power supply before connecting
wiring.
Location and Mounting (Fig. 1)
Mount the sensor where:
• cannot tamper with settings.
• there is good air circulation.
• it can measure true outdoor ambient temperature.
• surface is flat.
• wire distance between C7089U and thermostat is
less than 200 feet.
Do not mount the sensor:
• in direct sunlight.
• where hot or cold air blows on the sensor.
Discharge line from an outdoor compressor unit,
vent or fan causes inaccurate temperature
readings.
• where snow, ice or debris can cover it.
Use the following steps to mount the sensor:
1. Remove the sensor from the mounting clip.
2. Mark the area on the location selected for
mounting the sensor mounting clip.
3. Mount the clip.
69-1709EFS-05
Publicité
Table des Matières
Manuels Connexes pour Honeywell Home C7089U
Sommaire des Matières pour Honeywell Home C7089U
- Page 1 • it can measure true outdoor ambient temperature. Operating Ambient Temperature Range: • surface is flat. -40 to 120 °F (-40 to 49 °C). • wire distance between C7089U and thermostat is less than 200 feet. Display Range: -40 to 127 °F (-40 to 53 °C).
- Page 2 1. Wire the C7089U Outdoor Sensor to the appropriate S terminals on the thermostat or compatible device. If leadwire provided with C7089U is not long enough (60 in.), run a cable to a hole at C7089U location. a. Using color-coded, 18-gauge thermostat wire is recommended.
- Page 3 126021 reading. -23.8 119493 To verify sensor resistance, remove one wire from one 113347 of the C7089U 60-in. leadwires. Use an ohmmeter to -28.9 106926 measure the resistance across the sensor. Then verify -27.8 100923 the sensor accuracy with the temperature/resistance in Table 1.
- Page 4 69-1709EFS—05 M.S. Rev. 10-19 | Printed in United States This product is manufactured by Resideo Technologies, Inc., Golden Valley, MN, 1-800-468-1502 ©2019 Resideo Technologies, Inc. The Honeywell Home trademark is used under license from Honeywell International Inc. All rights reserved.
-
Page 5: C7089U Capteur Extérieur
Gamme de température ambiante de service : • la surface est plate; -40 à 49 °C (-40 à 120 °F ). • la distance du fil entre le C7089U et le thermostat est inférieure à 60 mètres. Gamme d’affichage : -40 à... - Page 6 1. Raccorder le capteur extérieur C7089U aux bornes S appropriées du thermostat ou du dispositif compatible. Si le conducteur fourni avec le C7089U n’est pas assez long (150 cm), faire passer un fil par une ouverture à l’endroit du C7089U.
-
Page 7: Fonctionnement
Le capteur extérieur C7089U convertit la température extérieure en une résistance lisible par le thermostat. Température extérieure Ohms de Le C7089U est à coefficient de température négatif, ce °F °C résistance qui signifie que la résistance diminue à mesure que la 195652 température augmente. -
Page 8: Température Extérieure
69-1709EFS—05 M.S. Rev. 10-19 | Imprimé aux États-Unis Ce produit est fabriqué par Resideo Technologies, Inc., Golden Valley, MN, 1-800-468-1502 ©2019 Resideo Technologies, Inc. La marque de commerce Honeywell Home est utilisée sous licence avec l’autorisation d’Honeywell International Inc. Tous droits réservés. - Page 9 -40 a 120 °F (-40 a 49 °C). verdadera. • la superficie sea plana. Intervalo de la pantalla: • la distancia al cable entre el C7089U y el -40 a 127 °F (-40 a 53 °C). termostato sea menor de 200 pies (60 m). Precisión del sensor: No instale el sensor: +/-1.5 °F a 70 °F (+/-.84 a 21 °C)
- Page 10 1. Cablee el sensor exterior C7089U a las terminales S adecuadas en el termostato o dispositivo compatible. Si el cable guía incluido con el C7089U no es lo suficiente largo (60 pulgadas, 1.5 m), tienda un cable por un orificio en la ubicación del C7089U.
- Page 11 OPERACIÓN CALIBRACIÓN Cerciórese de configurar el termostato o el dispositivo El sensor exterior C7089U está calibrado en la fábrica compatible para un sensor exterior cableado de 10K y no se puede recalibrar en el campo. ohmios. Las opciones de configuración del instalador varían por modelo de termostato/dispositivo.
- Page 12 69-1709EFS—05 M.S. Rev. 10-19 | Impreso en EE. UU. Este producto es fabricado por Resideo Technologies, Inc., Golden Valley, MN, 1-800-468-1502 ©2019 Resideo Technologies, Inc. La marca comercial Honeywell Home se utiliza en virtud de la licencia emitida por Honeywell International Inc. Todos los derechos reservados.