Trebs DIY Mode D'emploi page 43

Volume

Press the SET key to enter volume mode, and the
calculation of the volume of an area;

The length character "L" on the screen will blink showing length measurement will be taken.
Press READ key to take length measurement, the result will be displayed on the upper
portion of the screen. (Step 1)

The width character "W" on the screen will blink showing the next measurement to take.
Press READ key to take width measurement, the result will be displayed on the upper
portion of the screen. (Step 2);

The height character "H" on the screen will blink showing the next measurement to take.
Press READ key to take height measurement, the result will be displayed on the upper
portion of the screen. (Step 3);

After this the volume is automatically displayed on the lower portion of the screen;

Pressing the READ key again will toggle back and forth between the length, width and height
measurement on the upper portion of the screen;

Press SET key to clear the data on the portion of the screen, and then you can begin a new
volume calculation;

To choose between measurement modes, press the SET key again.
Tips:

Press the SET key one by one will toggle back and forth between the length, area, volume
and length measurement. If there is a datum on the display, first pressing the
clear the current datum, and the mode will be invariable.
will appear on the display for the
SET key will
43