Trebs DIY Mode D'emploi page 42


Pressing the READ key again will toggle back and forth between the length and width
measurement on the upper portion of the screen;

Press the SET key to clear the data on the portion of the screen; then you can begin the
calculation of a new area.

To choose measurement mode, press the SET key again;
Tips:

Press the SET key one by one will toggle back and forth between the length, area and
volume measurement. If there are datum on the display, first pressing the SET key will clear
the current datum, and the mode will be invariable.
Addition of area under area mode:

Press the M key to save the calculated area of the first measurement and at the same time,
the "M+" icon appears on the screen;

Press the SET key to clear the current displayed data, then you can begin the second
measurement and computation (follow step 1 and step 2 under the area section);

After getting the desired area of the second time computation, press +/= to enter the
addition mode. A "+" icon will appear on the LCD screen.

Press the RM key to recall the first calculated area for the addition. The "M+" icon will
disappear and the stored memory will be automatically cleared;

Press the +/= key, the sum of both areas is shown on the lower portion of the screen;

Repeat the steps above to keep adding a measured area.
42