Télécharger Imprimer la page

Publicité

Les langues disponibles

Les langues disponibles

Liens rapides

Limited One Year Warranty
T&S warrants to the original purchaser (other than
for purposes of resale) that such product is free from
defects in material and workmanship for a period of
one (1) year from the date of purchase. During this
one-year warranty period, if the product is found to
be defective, T&S shall, at its options, repair and/
or replace it. To obtain warranty service, products
must be returned to...
T&S Brass and Bronze Works, Inc.
Attn: Warranty Repair Department
2 Saddleback Cove
Travelers Rest, SC 29690
Shipping, freight, insurance, and other transpor-
tation charges of the product to T&S and the return
of repaired or replaced product to the purchaser are
the responsibility of the purchaser. Repair and/or
replacement shall be made within a reasonable time
after receipt by T&S of the returned product. This
warranty does not cover Items which have received
secondary finishing or have been altered or modi-
fied after purchase, or for defects caused by physi-
cal abuse to or misuse of the product, or shipment
of the products.
Any express warranty not provided herein, and
any remedy for Breach of Contract which might arise,
is hereby excluded and disclaimed. Any implied
warranties of merchantability or fitness for a particu-
lar purpose are limited to one year in duration. Under
no circumstances shall T&S be liable for loss of
use or any special consequential costs, expenses
or damages.
Some states do not allow limitations on how long
and implied warranty lasts or the exclusion or limi-
tation of incidental or consequential damages, so
the above limitations or exclusions may not apply
to you. Specific rights under this warranty and other
rights vary from state to state.
P/N: 098-009549-45 Rev.3
Date: 980120
Drawn: CW
Checked: JLT
Approved: MW
4-14-98
4-14-98
Installation and
Maintenance
Instructions
ATMOSPHERIC
VACUUM BREAKERS
B-0968 (3/8") & B-0969 (1/2")
(Also use for replacement parts,
B-0968-RK01 3/8" & B-0969-RK01 1/2")
Deutsch:
Español:
Français:
Installations- und
Wartungsanleitungen
la Instalación y las
Instrucciones de
Mantenimiento
les Instructions
d'Installation et
d'Entretien

Publicité

loading

Sommaire des Matières pour T&S B-0968

  • Page 1 Any express warranty not provided herein, and B-0968 (3/8”) & B-0969 (1/2”) any remedy for Breach of Contract which might arise, is hereby excluded and disclaimed. Any implied...
  • Page 2 Exploded View...
  • Page 3 Part Number Guide Vacuum Breaker Assemblies & Kit Screw, Self-tapping V.B. Namplate (3/8" or 1/2") Coverplate (3/8" or 1/2") Repair Kit 3/8" V.B. B-0968-RK01 Insert 009785-45 O'-Ring, Insert O'-Ring, Plunger 001066-45 Piston (3/8" V.B.) 009525-45 Repair Kit 1/2" V.B. B-0969-RK01...
  • Page 4 Typical Installation: Note: Where the device is a separate unit, in the absence of a Single Vacuum Breaker Critical Installation Level (CIL) mark, the extreme bottom of the 1. Vacuum breaker must be installed no.9 casting should be used to with the supply connected to the determine its installed position.
  • Page 5 Typical Installation: B-0968-RK01 (Kit) B-0969-RK01 (Kit) 3/8” Vac. Breaker 1/2” Vac. Breaker Follow the instructions in the Single Vacuum Breaker section, Step 1 thru step 5. Two typical T&S unit installations will look as follows: B-929 Atmospheric Vacuum Breaker Assembly 5.
  • Page 6 Instalación Típica: Nota: Donde el aparato sea una unidad separada, en la ausencia de Anti-sifón singular la marca (CIL) que significa nivel crítico de instalación, el lado 1. La válvula anti-sifón tiene que ser extremo posterior de la parte No.9 instalada, con la fuente surtidora en la debe ser utilizado para determinar parte posterior y la salida conectada a...
  • Page 7 1 al 5. 4. Reemplaze con partes nuevas del estuche de reparo. Dos instalaciones de unidades tipicas de T&S se verán como lo siguiente: B-0968-RK01 3/8” B-0969-RK01 1/2” Válvula Anti-sifón Válvula Anti-sifón B-929 Ensamblado De Válvula Anti-sifón Atmosférica B-657 Canilla 5.
  • Page 8 Noter: Si le dispositif être un L’Installation Typique: élément séparé, avec l’absence d’une ligne du Niveau de La Vanne-Caisse-Vide L’Installation Critique (CIL), le 1. La vanne-caisse-vide devoir être fond extrême de la coulée de N°.9 installer avec l’alimentation brancher devoir être utiliser pour déterminer au fond et la sortie brancher à...
  • Page 9 L’Installation Typique: B-0968-RK01 B-0969-RK01 (Trousse) 0,96 cm (Trousse) 1,28 cm Suivre les instructions dans la section de la vanne-caisse-vide, de l’étape 1 jusqu’ à l’étape 5. Deux installations typiques des éléments de T&S aller avoir l’aspect comme indiqué au-dessous: B-929 la Vanne-Caisse-Vide Atmosphérique...
  • Page 10 Normale Installation: Anmerkung: Falls das Gerät eine separate Einheit ist, ist, falls eine Einfacher Vakuumschalter kritische Einbauebene fehlt (CIL), 1. Bei der Installation des nach der Installation der äußerste untere Rand des Gußstückens Nr.9 zur Vakuumschalters muß die Zuführung Festlegung seiner Lage zu verwenden. wie gezeigt mit dem unteren Ende, Falls das Gerät Teil eines Ausflußrohrs, und das Ausflußrohr wie gezeigt mit...
  • Page 11 Normale Installation: B-0968-RK01 0,96 cm (Instandsetzungssatz) Die Anleitungen fur den einfachen oder B-0969-RK01 1,28 cm Vakuumschalter, Schritt 1 bis 5, (Instandsetzungssatz) befolgen. Die Installation von zwei typischen T&S Einheiten sieht wie folgt aus: B-929 Atmosphariche Vakuumechalicrvorrichtung 5. In umgekehrter Anordnung wieder zusammensetzen.
  • Page 12 RELATED T&S BRASS PRODUCT LINE B-0965 Atmospheric Vacuum Breaker Assembly with Exposed Outlet B-0929 Atmospheric Back Flow Preventer B-0456 Atmospheric Vacuum Breaker Assembly T&S BRASS AND BRONZE WORKS, INC. A firm commitment to application-engineered plumbing products 2 Saddleback Cove, P.O. Box 1088, T &...

Ce manuel est également adapté pour:

B-0969