Alto Professional TS212W Guide D'utilisation page 3

Example 2
Microphone
Example 3
Connect the left and right output of your DJ mixer, controller, etc. to Input 1 of each
loudspeaker using XLR or 1/4" (6.35 mm) TRS cables.
Tip: To send the same mix to both TS2W Series loudspeakers, connect both channels of your
DJ mixer, controller, etc. to the Input 1 and Input 2 of one loudspeaker, and then connect that
loudspeaker's Mix Out to the Input 1 of the other loudspeaker. Both TS2W Series
loudspeakers will then play identical summed mono mixes.
Guitar
with
active
pickup
Power
Connect a dynamic microphone to the Input 1
using an XLR or 1/4" (6.35 mm) TRS cable.
Connect a guitar with an active pickup to the Input
2 using a 1/4" (6.35 mm) TS or TRS cable (see your
guitar's documentation for cable requirements).
Note: When using the TS2W Series loudspeaker
with a guitar, we recommend using one with active
pickups rather than passive pickups. If you use a
guitar with passive pickups, connect it to an
external preamp or direct input (DI) box, and
connect the line-level output to the loudspeaker.
Also, use dynamic microphones with the TS2W
Series loudspeaker
microphones. If you use a microphone that
requires +48 V of phantom power, connect it to an
external phantom power supply before connecting
it to the loudspeaker.
rather than
DJ controller,
Mixer, etc.
Power
condenser
3