Publicité
Les langues disponibles
Les langues disponibles
Gigabit Ethernet Switch
CONNECTIONS & INDICATORS
LNK/ACT
PWR
LEDs
The LED indicators — Power, Link/
Activity — make it easier to monitor
the switch and its connections.
Ports
All ports on the switch support
Auto-MDI/MDI-X functionality, so
crossover cables and uplink ports are not needed for connections to
PCs, routers, other switches, etc. Cat5/5e/6 UTP/STP cables provide
optimal performance; if a status LED doesn't indicate a link or activity,
check the corresponding device for proper setup and operation.
Power
Use the included power cord to connect the device (on the rear panel)
to an AC outlet. Confirm that the power LED on the front panel is lit.
INSTALLATION
The switch includes brackets and screws for optional rack mounting:
1. Disconnect any cables from the switch.
2. Position a bracket over the mounting holes on one side of the switch
and secure it in place with screws (Page 11).
3. Repeat Step 2 on the other side of the switch.
4. Position the switch in the rack and screw the brackets to the rack.
5. Reconnect any cables.
Prior to use, it is recommended that the switch be placed/positioned
on a level surface with at least 25 mm (approx. 1") of clearance for
ventilation; away from sources of electrical noise: radios, transmitters,
broadband amplifiers, etc.; and within 100 m (approx. 328') of network
devices it's to be connected to.
For specifications, go to intellinetnetwork.com.
2
ENGLISH
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
1
2
9
10
LED
Status
Operation
PWR
On
Power on
Off
Check the AC connection;
turn the power on
LNK/ACT On
Valid port connection
Blinking Valid port connection; data
transmitted/received
Off
No link established
English
3
4
11
12
Publicité
