Husqvarna 325iLK+TAB850 Manuel D'utilisation page 11

2. Align the tab (A) with the arrow (B) on the coupling.
3. Push the shaft into the coupling until it clicks into
position.
4. Tighten the knob fully.
1385 - 002 - 04.12.2019
B
A
To disassemble the two-piece shaft
1. Turn the knob 3 turns or more to loosen the
coupling.
2. Push and hold the button (C).
3. Hold tight in the end of the shaft that the motor is
attached to.
4. Pull the attachment out of the coupling.
C
To install the suspension ring if
applicable
1. Install the suspension ring between the arrows on
the rear handle and the loop handle.
Note: Do not put the loop handle on the decal.
2. Adjust the ring to make the product balanced, and
easy to use.
11