Publicité
Les langues disponibles
Les langues disponibles
V1.0
WARNING! Before lowering the load or vehicle, ensure thatthere are no
obstructions underneath and that all people arestanding clear.
1.
Open the valve by gradually twisting to the left.
2.
The load will begin to lower.
3.
Twist right to slow and left to increase the rate of descent.
4.
Remove the jack once the load is on the ground or a support
mechanism like jack stands.
5.
The ram should fully retract. If it does not, push down on it until it is seated.
CARE & MAINTENANCE
1.
Maintain the tool with care. A tool in good condition is efficient, easier
to control and will have fewer problems.
2.
Inspect the tool components periodically. Repair or replace damaged or
worn components. Only use identical replacement parts when servicing.
3.
Follow instructions for lubricating and changing accessories.
4.
Keep the tool clean, dry and free from oil/grease at all times.
5.
Maintain the tool' s labels and name plates. These carry important
information. If unreadable or missing, contact Princess Auto Ltd. for
replacements.
6.
Have a qualified technician inspect the jack:
a.
Once a year.
b.
After receiving a shock load. Take the jack out of service until the
technician certifies that it is safe to use.
WARNING! Only qualified service personnel should repair the tool. An
improperly repaired tool may present a hazard to the user and/or others.
HYDRAULIC RAM MAINTENANCE
Monthly maintenance is recommended for the hydraulic ram. Any restrictions
due to dirt, rust, etc. can cause the either slow movement or extremely rapid
jerks, damaging the internal components. The following steps are designed to
keep the pump maintained and operational.
1.
Lubricate the cylinder and the pumping mechanism with light oil.
2.
Visually inspect for cracked welds, bent, loose, missing parts or hydraulic
oil leaks.
Visit www.princessauto.com for more information
Low-Profile Floor Jack
8911307
9
Publicité
