Publicité
Les langues disponibles
Les langues disponibles
V1.0
UNPACKING
WARNING! Do not operate the tool if any part is missing. Replace the
missing part before operating. Failure to do so could result in a malfunction
and personal injury.
Remove the parts and accessories from the packaging and inspect for damage.
Make sure that all items in the contents are included.
Contents: • Low-Profile Floor Jack • (2) Handle
IDENTIFICATION KEY
A
Wheel
B
Saddle
C
Frame
D
Lifting Arm
ASSEMBLY & INSTALLATION
Numbered references in parenthesis (#1) refer to the included Parts List.
Letter references in parenthesis (A) refer to the included Identification Key.
1.
Hold the handle socket down (F) and remove the retaining clip. Allow
the handle socket to slowly raise into the rest position.
2.
The handles are locked together with a quick disconnect lock pin (#40).
Press the lock pin button on the upper handle (#41) and slide the upper
handle into the lower handle. Align the button with the hole and it will
lock the upper and lower handle together. Push the button in and pull
the handles apart to separate the two halves when storing.
3.
Unscrew the set screw (H) by hand until it no longer protrudes into the
socket (F). Push the handle in as far as possible. Fit the square hole at
the end of the handle over the square bolt inside the handle socket.
Tighten the screw to lock the handle in place.
Visit www.princessauto.com for more information
Low-Profile Floor Jack
E
Zerk Fitting
F
Handle Socket
G
Handle
H
Set Screw
I
Dual Pump Plunger
J
Swivel Caster
8911307
7
Publicité
