Operating The Trimmer - Black+Decker BESTA510 Mode D'emploi

English
Fig. H
Releasing the cutting line
For shipping purposes, the cutting line is taped to the
spool housing.
• Remove the tape holding the cutting line to the
spool housing.
• See "Replacing the Spool" for instructions for removing
the spool
OPERATION

WARNING: To reduce the risk of serious personal
injury, turn unit off and disconnect it from
power source before making any adjustments or
removing/installing attachments or accessories.
An accidental start-up can cause injury.

WARNING: Always use proper eye protection that
conforms to ANSI Z87.1 (CAN/CSA Z94.3) while
operating this appliance.

CAUTION: Before you begin trimming, only use the
appropriate type of cutting line.

CAUTION: Inspect area to be trimmed and remove
any wire, cord, or string-like objects which could
become entangled in the rotating line or spool. Be
particularly careful to avoid any wire which might be
bent outwardly into the path of the trimmer, such as
barbs at the base of a chain link fence.
Proper Hand Position (Fig. I)

WARNING: To reduce the risk of serious personal injury,
ALWAYS use proper hand position as shown.

WARNING: To reduce the risk of serious personal
injury, ALWAYS hold securely in anticipation of a
sudden reaction.
Proper hand position requires one hand on the main
handle 3 and one hand on the auxiliary handle
Switching on and off
To switch the trimmer on, squeeze the trigger switch
To switch the trimmer off, release the trigger switch.

Operating the Trimmer

• With the unit on, angle unit and slowly swing the
trimmer side to side as shown in Fig. I.
• Maintain a cutting angle of 5° to 10° as shown in Fig. I1.
Do not exceed 10° (Fig. I2). Cut with the tip of the line.
To keep distance from hard surfaces use edge wheel
6
2 14
3
5 .
.
1
7
• Maintain a minimum distance of 24 inches (609.6 mm)
between the guard and your feet as shown in Fig. I. To
acheive this distance adjust the overall height of the
trimmer as shown in Fig. G.
Fig. I
Fig. I2
Convert to Edging Mode (Fig. K)
The trimmer can be used in trimming mode or edging
mode to trim overhanging grass along lawn edges and
flower beds.

WARNING: Disconnect the plug from the power
source before making any adjustments.

WARNING: When being used as an Edger, stones,
pieces of metal and other objects can be thrown out
at high speed by the line. The trimmer and guard
are designed to reduce the danger. However, MAKE
SURE that other persons and pets are at least 100 feet
(30m) away.
• To operate as a maintenance edger, turn the collar
shown in Fig. K.
• Hold the metal shaft and rotate the lower housing 180°
as shown in Fig. K.
• Turn the collar back until tight.
nOTE: The metal shaft and housing will only rotate in
one direction.
• To return to the trimming position, loosen the lock
collar and rotate the lower housing back 180° and
retightening the collar.
.
Fig. I1
Fig. I3
5
as