Black+Decker BESTA510 Mode D'emploi page 10

English
Use BLACK+DECKER replacement spool Model No. AF-100,
and replacement cap RC-100.
Reload nylon line (either bulk or prewound replacement
spool) as shown in this manual.
• USE ONLY .065 inch (1.65 mm) DIAMETER ROUND
NYLON LINE. Do not use serrated or heavier gauge line,
as they will overload the motor and cause overheating.
This line is available at your local dealer or authorized
service center.
• Other replacement parts (guards, spool caps, etc.) are
available through BLACK+DECKER service centers. To
find your local service location call: 1-800-544-6986 or
visit www.blackanddecker.com.
Replacing the Spool (Fig. M, N, O, P)

WARNING: To reduce the risk of serious personal
injury, turn unit off and disconnect it from
power source before making any adjustments or
removing/installing attachments or accessories.
An accidental start-up can cause injury.
• Unplug trimmer.
• Depress the tabs 15
from the spool housing
(Fig. M).
Fig. M
25
16
• For best results, replace spool with BLACK+DECKER
model no. AF-100.
• Grasp empty spool with one hand and spool housing
with other hand and pull spool out.
• If lever 17 (Fig. N) in base of housing becomes
dislodged, replace in correct position before inserting
new spool into housing.
Fig. N
8
and remove the spool cap
16 in the trimmer head
15
18
19
17
• Remove any dirt and grass from the spool and housing.
• Unfasten the end of the cutting line and guide the line
into the eyelet
Fig. O
• Take the new spool and push it onto the boss
the housing (Fig. N). Rotate the spool slightly until it is
seated. The line should protrude approximately 5-3/8
inches (136mm) from the housing.
25
• Align the tabs on the spool cap with the slots
housing (Fig. P).
• Push the cap onto the housing until it snaps securely
into place.
Fig. P

CAUTION: To avoid trimmer damage, if the cutting
line protrudes beyond the trimming blade, cut it off so
that it just reaches the blade.
Rewinding Spool From Bulk Line (Fig. Q, R, S)
(use only .065 in. ROUnD diameter line)
Bulk line is also available for purchase from your local
retailer. nOTE: Hand wound spools from bulk line are likely
to become tangled more frequently than BLACK+DECKER
factory wound spools. For best results, factory wound spools
are recommended.
To install bulk line, follow the steps below:
• Unplug trimmer.
• Remove the empty spool from the trimmer as described
in "REPLACING THE SPOOL".
• Remove any remaining cutting line from the spool.
• Make a fold at the end of the cutting line at about 3/4
inch (19mm)
line anchoring slots
19 Fig. O.
19
21 . Feed the cutting line into one of the
22 as shown in Fig. O.
in
18
20 in the
20