D-Link DGS-1005D Guide D'installation page 4

MOUNTING
WALL CONFIGURATIONS
The DGS-1005D/1008D can be mounted to a wall. Two mounting slots are provided
on the bottom of the switch for this purpose. Please make sure that the front
panel is exposed in order to view the LEDs. Please refer to the illustration below:
A. MOUNTING ON A CEMENT WALL
1. Mount the Nylon screw anchors into a cement wall.
2. Drive the T3 x 15L screws into the Nylon screw anchors.
3. Hook the mounting holes of the switch back onto the screws.
B. MOUNTING ON A WOOD WALL
1. Drive the T3 x 15 L screws into the wood wall.
2. Hook the mounting holes of the switch back onto the screws; you have completed the wall-mount.
C. MOUNTING ON A METAL WALL
1. Mount the magnetic base screws (optional) onto the mounting holes of the switch.
2. Attach the switch to a metallic surface.
Note: The mounting and magnet kits are not included in the package.
4
a) Minimum 3/4 inch screw required for wood wall
b) Minimim 3 inch screw required for cement wall
DGS-1005D/1008D