Publicité
Les langues disponibles
Les langues disponibles
• Do not attempt to repair the
equipment yourself unless you
have been trained to do so.
Any work not specified in these
instructions is to be carried out
only by customer service cen-
tres that we have authorised.
• Keep the equipment in a dry
location and out of reach of
children.
• Handle the equipment with
care. Keep tools sharp and
clean, in order to facilitate bet-
ter and safer work. Follow the
maintenance instructions.
• Wear protective gloves when
changing the cutting device.
• Regularly check the grass col-
lection device for wear and
strains. For safety reasons, re-
place worn or damaged parts.
When adjusting the blades,
take particular care to avoid
fingers being trapped between
the rotating blades and fixed
parts of the machine.
• Check that only replacement
tools authorised by the manu-
facturer are used.
• Before you shut down the ma-
chine, let the motor cool down.
Residual Risks
Even if properly operating and
handling this electric tool, some
residual risks will remain. Due
to its construction and build, this
electric tool may present the fol-
lowing hazards:
a) Cuts
b) Ear damage if working without
ear protection.
c) Damage to your health caused
by swinging your hands and
arms when operating the appli-
ance for longer periods of time
or if the unit is not held or main-
tained properly.
Warning! During operation,
this electric tool generates an
electromagnetic field which,
under certain circumstances,
may impair the functionality
of active or passive medical
implants. To reduce the risk
of serious or lethal injuries,
we recommend that per-
sons with medical implants
consult their doctor and the
manufacturer of their medical
implant before operating the
machine.
Assembling instructions
•
Alwayas wear cut-protection gloves
•
Undertake only work with which you
are confident.
•
In case of uncertainty, contact a spe-
cialist or contact our service directly
Install lower bar
1. Pull the ends of the lower bar (4)
slightly apart and place them into the
recess on the device housing (10).
2. Move the lower bar into position using
the supplied hex bolts and lower wing
nuts (5).
3. Turn the lower wing nuts (5) clockwise
to fasten.
GB
27
Publicité
