Table des Matières
Publicité
üFit
CUSTOMIZABLE CONTOUR SUPPORT BACK
™
1. Customization
üCube
sets can be removed
™
completely, or cut for greater
customization. To remove/cut,
first unzip both zipper pulls on
the cover and fold the front of
the cover down. Remove the
center foam overlay, to expose
the üCube
. To remove the
™
üCube
, grasp the cube set by
™
the darker coloured closed cell
foam base and gently pull up –
the cube will release from the
back shell.
If cutting, cut the üCube
shell by aligning the studs (white pins on the underside of the üCube
the holes and pushing back into place until an audible click is heard. Once
all desired customization is complete, re-install the center foam overlay and
zip-up the cover.
2. Installing Head Support
To install a head support on the üFit
you must remove the cover fabric that
overlays the slots which the
head support is installed
in. Coneveniently, there
is a punched template to
follow. Simply connect
the ends of the existing
cuts with scissors or a
knife to remove the
rectangle of fabric.
Next remove the back cover and then the üCube
around the mounting slots. Install the mounting hardware and adjust the
angle as desired by rotating the bracket slightly either clockwise or counter
clockwise.
Reassemble the üCube
through the hole cut into the cover.
once it has been removed, and re-install on back
™
,
™
and cover ensuring the mounting hardware fits
™
that are in the area
™
) with
™
17
Publicité
Table des Matières
