Installation (See Figure 2); Fuel - MW TOOLS WD70I Mode D'emploi

M1.1.WD70I.NLFREN - 25042019
EN

3 Installation (see figure 2)

【10.Installation】
1. Open the two screws on the fixed rings.
2. Put the protection panel on the designated spot to meet the screw holes.
3. Set the screws with the protection panel.
4. Front grill installation
5. Handle installation
6. Stand installation
【10.Installation】
1.Open the two screws on the fixed rings
2.Put the protection panel on the designated spot to meet the screw holes.
3.Set the screws with the protection panel
1.Open the two screws on the fixed rings
1
2.Put the protection panel on the designated spot to meet the screw holes.
3.Set the screws with the protection panel
4
Figure 2
1. Front grill installation
2. Handle installation

4 Fuel

Stand installation
3.
WARNING!
The generator only runs on DIESEL or KEROSENE fuel.
1. Front grill installation
2. Handle installation
To avoid fire or explosion, use only diesel or kerosene fuel. Do not use gasoline, naphtha, paint thinners, alcohol or any other
combustible liquids.
Stand installation
3.
For low-temperature operation, use antifreeze supplements.
1
1
2
5
2
2
19
3
6
3
3