Miele XKM 3200 WL LMD Mode D'emploi page 49

Opening the
menu
Checking the
connection status
Switch the cleaning machine on using the  button.

You must wait approx. 90 seconds before starting to configure the in-
terface.
Open the menu as follows:

 button
Further settings

 Interface
Interface
Ethernet
RS232
Ethernet
Select the

The following options are available:
- Module status
Displays the connection status.
DHCP
-
The Ethernet interface can either be implemented via a Dynamic
Host Configuration Protocol (DHCP) or by setting the individual
parameters.
Module status
Select the

Active
The following messages may appear in the display:
Active
-
The module is ready for operation.
- Initialising, module not yet active
The module has not finished initialising. This process takes approx.
90 s.
Inactive
-
No module has been detected.
Check the installation of the module. Switch the cleaning machine
off and then back on again.
If the message continues to appear, contact the Miele Customer
Service Department.
en - Network connection
interface and confirm your choice with OK.
option and confirm your choice with OK.
49