Publicité
Les langues disponibles
Les langues disponibles
en - Network connection
LAN cable
WPS login
WiFi access point If you do not wish to set up a WPS connection and the module has
48
Establishing the WiFi connection
Do not connect the LAN cable to the network. Plugging in the LAN
cable switches off the WiFi signal automatically. The technology does
not support the simultaneous use of WiFi and LAN.
WPS login requires the use of a WPS-enabled WiFi router or repeater.
Switch the cleaning machine on.
After around 90 s, the module is ready for operation.
Briefly press the button on the module (1–4 seconds).
Never press the button for more than 4 seconds, as this will reset
the module to the factory default settings; see Reset button.
Activate the WPS function on your WiFi router or repeater within
2 minutes.
The LED on the module will light up green if the WPS login is suc-
cessful.
not yet been configured for a WiFi network, a WiFi access point will
open automatically when the cleaning machine is switched on. You
can connect the access point to your PC.
To do this, switch the cleaning machine on.
After around 90 s, the module is ready for operation.
Configure the interface of your cleaning machine. To do this, follow
the instructions in the "Configuring the interface" chapter.
Open the module's web interface and configure the interface under
"WiFi Settings"; see "Configuring the interface".
Configuring the interface
Under no circumstances must the internet be accessed via the
washer-disinfector, e.g. via port forwarding!
Make sure that your Internet connection or your router is con-
figured accordingly.
Only specialists are permitted to configure the interface.
Publicité
