Gallagher 055654 Notice D'installation page 5

3. Switch the magnet slowly back and forth between OFF
and ON a few times; continue until the lamp flashes
blue once. Now leave the magnet switched to ON.
4. Wait until the Gallagher FenceAlarm lamp flashes alternately blue
and green. The Gallagher FenceAlarm is now connected with the
GSM network. You now have a maximum of 2 minutes to carry out
step 5.
If the lamp stops flashing blue and green, then you have to carry out
steps 2 to 4 again.
5. Send the SMS text message to the number of the SIM card in the
Gallagher FenceAlarm.
6. After a few minutes you will receive a status message. This status
message is explained later on in this guide, but in the status
message you should see "M1:" followed by your telephone
number.
5. Installation of the FenceAlarm
For optimal operation, the Gallagher FenceAlarm must be located as far
away as possible from the energiser. The length of the fencing to the right
of the FenceAlarm should preferably be the same as the length of the
fencing to the left.
The fencing must be disconnected in both directions at the FenceAlarm.
You can do this by attaching the fencing from both directions to 2 separate
insulators.
Connect the red clamp of the FenceAlarm to the left/right part and
connect the yellow clamp to the other part of the fence line.
The green clamp needs to be connected to an earth peg (not included).
4