Publicité
Les langues disponibles
Les langues disponibles
Puls> 1.2sec
If you use your own mobile telephone to change the settings of the
FenceAlarm you will be sent a settings SMS message.
SETTINGS
M1:+31611112222
V37
GV:32
DT:30
TM:006
DG:168
to a 10th of a kilovolt (i.e., in multiples of 100V)
Measured interval between 2 pulses. This interval is
measured for you. Some energisers increase the
pulse interval when the power pack level is low. If
this happens, you know the power pack of the
energiser needs to be replaced.
Telephone number the SMS is sent to by the
FenceAlarm. This should be the mobile telephone
number of the fence owner. Tip: always use the
country code for the mobile phone number.
Software version. This tells you the software version
installed on the FenceAlarm.
Perimeter Voltage is 3.2kV.This is the minimal value
that will activate the FenceAlarm in sending a
FenceAlarm SMS message.
The day timer is set at 30 days. You can set the time
that the battery of your energiser will last. The
FenceAlarm will send a FenceAlarm SMS message
after 30 days.
TM is short for time. The alarm will be repeated
every 6 hours. If you receive an alarm message, the
FenceAlarm will continue sending (reminder)
messages to you at a set interval.
DG is short for daily message. A status message will
be sent once every 168 hours (once per week). At set
intervals the FenceAlarm will send you a status SMS
message to keep you informed about the current
status of your fence. In this way the FenceAlarm lets
you know that everything is still working properly.
The standard setting is for the SMS to be sent at
20:00 hours. However, you still have to set the time
11
Publicité
