Connect Telephone / Network Surge Protection And Usb - Atlantis Host Power 1001 Mode D'emploi

1.5 Connect telephone / Network Surge protection and USB

Connect a single line telephone or a 10 base-T / 100 base-T network cable into the
RJ-45 / RJ-11 telephone / network surge protection "IN" jack on the back of the
UPS. Connect from the "OUT" jack with telephone cable (supplied) or network
cabling (not supplied) to a fax modem or network port.
Connect the supplied interface cable to the USB (or RS232) computer interface port
on the back of the UPS. Connect to the computer. See software document for
installation instruction.
30