A.1.2 Upsilon2000; A.1.3 Battery And Fuse - Atlantis Host Power 1001 Mode D'emploi

normally, but
lit.

A.1.2 Upsilon2000

Situation
How to install the
UPSilon2000.
PC doesn't find the
UPS.

A.1.3 Battery and Fuse

Situation
Backup time
Wich type
battery does UPS
use?
How often do
have to change
battery?
Where can I find
batteries?
How can I check
the Fuse?
Fuse specification.
as missing ground or hot
is
to neutral wire reversal.
Once started the UPS you can connect it to PC through USB
cable. At this time the SO detects and installs automatically all
drivers. Now you can install UPSSILN2000 on the PC.
1. Check if the cable is properly connected
2. Use the original cable
3. Launch Upsilon2000, then click on INSTALLATION and
check that TYPE OF COMMUNICATION is (USB).
The battery backup time (sometime called battery reserve
time or battery autonomy) is the length of time the battery
will supply power to the load during a power failure. You can
check on the Appendix Backup Time.
of  2 x 12VDC- 7.2A/h nell'A03-HP1001
 2 x 12VDC- 9A/h nell'A03-HP1501

4 x 12VDC- 7.2A/h nell'A03-HP2001
 4 x 12VDC- 9A/h nell'A03-HP3001
I Atlantis recommends to replace the batteries once a year.
1. please contact Your reseller.
2. please contact directly Atlantis.
Check the fuse to be sure it is not blown or damaged. Also,
make sure the fuse makes good contact and is not loose in the
fuse holder. Ensure that you are using the correct size fuse. If
you replace the fuse and the UPS again blows the fuse, please
contact Atlantis.
[10A, 250Vac](A03-HP1001) / [12A, 250Vac]
You can found on the rear panel (AC Fuse holder) a fuse.
Solution
Solution
42
electrician in order to
correct the building
wiring.