Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
EN
REMOTE CONTROL
1. fast / anti-clockwise
2. medium / anti-clockwise
3. slow / anti-clockwise
4. medium / clockwise
5. fast / clockwise
6. slow / clockwise
APPLICATION
Any target can be aimed at manually by use of the remote control. This
function is also available for lasers without pulse function.
Advantage: Time saving as nor the receiver must be used neither the tracking function must be called
up. It is not necessary to fix the receiver at the target; the setting is made manually with the remote
control only.
USE OF THE RECEIVER WITHOUT TRACKING FUNCTION
Without using the tracking function the receiver can be used in horizontal and vertical direction.
POWER ON
Press button (4) (the power LED will light red). Activate the pulse function (P) of the receiver.
Now the receiver is in reception mode and the sound is set to „low" . Press button (4) again to power off
the receiver. Three short beeps will sound.
Keep button (1) pressed to power on and off the sound.
·
Keep it pressed once = sound ON - confirmation by a beep
·
Keep it pressed twice = sound OFF - confirmation by two beeps
Move the receiver up and down carefully to detect the laser beam.
Detection of the laser signal:
A
Move the receiver down - acoustic signal: ultra-short frequent beep
B
Move the receiver up - acoustic signal: short frequent beep
C
On level - acoustic signal: continuous beep
16
6
5
4
1
2
3
Publicité
Table des Matières
