geo-FENNEL EasyTRACK Plus Mode D'emploi page 14

EN
AUTOMATIC TRACKING FUNCTION
For the axis alignment (vertical line)
· Fix the line laser on the EasyTRACK Plus
· Power on the line laser and activate the reception mode
· Position the line laser over the ground point
· Press the POWER button (2) of the EasyTRACK Plus (the LED will light red)
· Power on the receiver (button 4)
· Select the distance LONG/SHORT with button (1): SHORT = 8 - 10 m, LONG = more than 10 m
· Position the on-grade mark of the receiver at the target point and power on AUTO (button 6); the
unit will now prepare the tracking procedure.
· Select the tracking directon with the arrow buttons LEFT or RIGHT.
The tracking procedure will start and a discontinuous beep will sound.
As soon as the laser line has reached the on-grade position of the receiver a permanent beep will sound
and the receving status indication of the display will light green.
In case the laser cannot find the on-grade position the procedure has failed and the receiver will beep
three times. Re-start the procedure with AUTO.
For a new on-grade position the procedure must be re-started with AUTO.
14