Beko BEHPGH 090 Manuel D'utilisation page 18

2 Unit specifications and features
• Sleep operation
• The SLEEP function is used to decrease energy
use while you sleep (and don't need the same
temperature settings to stay comfortable).
This function can only be activated via remote
control. And the Sleep function is not available
in FAN or DRY mode.
• Press the SLEEP button when you are ready
to go to sleep. When in COOL mode, the unit
will increase the temperature by 1°C (2°F) after
1 hour, and will increase an additional 1°C (2°F)
after another hour. When in HEAT mode, the
unit will decrease the temperature by 1°C (2°F)
after 1 hour, and will decrease an additional 1°C
(2°F) after another hour.
The sleep feature will stop after 8 hours and the
system will keep running with final situation.
SLEEP Operation
Cool mode (+1°C/2°F) per hour
for the first two hours
Set
temperature
1hr
Heat mode (-1°C/2°F) per hour
for the first two hours
Saving energy during sleep
Note: For multi-split air
condtioners, the following
functions are not available:
C
SelfClean+, GoClean function,
Silence feature, Breeze away
function, Refrigerant leakage
detection function and Eco
feature.
18 / 324 EN
Keep running
1hr
• Setting Angle of Air Flow
2.5.1 Setting vertical angle of air
flow (See Fig.A)
While the unit is on, use the SWING button on
remote control to set the direction (vertical angle)
of airflow. Please refer to the Remote Control
Manual for details.
Note: Do not move louver by
hand. This will cause the louver to
C
become out of sync. If this occurs,
turn off the unit and unplug it for a
few seconds, then restart the unit.
This will reset the louver.
Fig. A
Split type air conditioner / User Manual