hestan GIMR15 Mode D'emploi page 9

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

INSTALLATION INSTRUCTIONS
1. Make sure the space opening is correctly sized for the unit. See typical appliance dimensions on
page 7 and the chart below for finished rough opening requirements:
HEIGHT
34" [86.4 cm] min.
34-1/2" [87.6 cm] max.
2. Check that the following are level and square:
• Front and interior opening
• Installation opening and floor surface
• Countertop bottom front edge
NOTE: The floor under the unit must be at the same level as surrounding finished floor.
To prevent possible damage to the countertop, do not place heavy objects on countertop directly
over unit.
Do not let the weight of the countertop rest on the ice machine.
Do not install the ice machine in a corner where the door will interfere with other equipment or
where the ice machine cannot be pulled out for service.
The louvered sections at the front and rear of the unit must not be covered or obstructed.
Obstructions could prevent proper air circulation, which may damage the unit.
Between Two Cabinets
Min. 34"
(864 mm)
Min. 15"
(381 mm)
Between a Cabinet and
a Wall or Tall Cabinet
Secure: Do not
let the weight
of the counter
rest on the ice
machine
WIDTH
DEPTH
15" [38.1 cm]
24" [61 cm]
(continued)
Between a Cabinet and
the End of a Counter
Min. 34"
(864 mm)
Min. 15"
(381 mm)
In a Corner
Oven
©2021 Hestan Commercial Corporation
EN
Support: Do not
let the weight
of the counter
rest on the ice
machine
Ice machine
9

Publicité

Chapitres

Table des Matières
loading

Ce manuel est également adapté pour:

Giml15

Table des Matières