Installation Instructions - hestan GIMR15 Mode D'emploi

INSTALLATION INSTRUCTIONS

This ice machine must be installed in accordance with applicable national, state, and local codes
EN
and regulations.
CHOKING HAZARD
after installation. Make sure that none have fallen into the storage bin.
CHECKS BEFORE INSTALLATION CHECKS BEFORE INSTALLATION
• Visually inspect the exterior of the shipping container and immediately report any damage to
the carrier. Upon opening the container, any concealed damage should also be immediately
reported to the carrier.
• Remove the shipping carton, tape, and packing material. If any are left in the ice machine, it
will not work properly.
• Remove the package containing the accessories.
• Remove the protective plastic film from the panels. If the ice machine is exposed to the sun
or to heat, remove the film after the ice machine cools.
• See the nameplate inside the storage bin, and check that your voltage supplied corresponds
with the voltage specified on the nameplate.
LOCATION LOCATION
This ice machine is approved for indoor or outdoor use.
• Normal operating ambient temperature must be within 45 to 100°F [7 to 38°C] Normal
operating water temperature must be within 45 to 95°F [7 to 35°C]. Operation of the ice
machine, for extended periods, outside of these normal temperature ranges may affect ice
machine performance.
• This ice machine will not work at sub-freezing temperatures. To prevent damage to the
water supply line, drain the ice machine if the air temperature is going to go below 32°F [0°C].
See page 20 "Preparing the Ice Machine for Periods of Non-Use."
For best operating results:
• The ice machine should not be located next to ovens, grills, or other high heat producing
equipment.
• The location must provide a firm foundation for the ice machine.
• This ice machine requires no side or top clearance. But allow enough space at rear for water
supply and drain connections and at least 15" [38 cm] clearance at front.
• The ice machine must be at floor level on a finished floor even if under a cabinet. In areas
where water damage is a concern, install in a contained area with a floor drain.
PREPARING THE SPACE PREPARING THE SPACE
If the unit is to be installed under a countertop, it is recommended that the countertop be
supported by a structure other than the unit itself to prevent damage to the unit.
Make sure the floor under the unit is level with the surrounding finished floor. Protect a finished
floor with plywood, cardboard, or some other suitable material before moving the unit into place.
Failure to do this may result in damage to the floor.
8
©2021 Hestan Commercial Corporation
: Ensure all components, fasteners, and thumbscrews are securely in place