Regulatory/Code Requirements; Important Safety Information - hestan GIMR15 Mode D'emploi

REGULATORY / CODE REQUIREMENTS
Installation of this appliance must be made in accordance with local codes. In the absence of local
codes, this unit should be installed in accordance with the National Electrical Code and local codes.
EN
This appliance must be electrically grounded in accordance with local codes or in the absence of
local codes with the National Electrical Code ANSI/NFPA 70 , or Canadian Electrical code CSA
C22.1 .

IMPORTANT SAFETY INFORMATION

This ice machine should be destined only to the use for which it has been expressly conceived. Any
other use should be considered improper and therefore dangerous. The manufacturer cannot be held
responsible for injury or damage resulting from improper, incorrect, and unreasonable use. Failure
to install, operate, and maintain the ice machine in accordance with this manual will adversely affect
safety, performance, component life, and warranty coverage and may result in costly water damage.
To reduce the risk of death, electric shock, serious injury, or fire, follow basic precautions including
the following:
• Only qualified service technicians should install and service this ice machine.
• This ice machine must be installed in accordance with applicable national, state, and local codes
and regulations.
• This ice machine requires an independent power supply of proper capacity. See the nameplate
for electrical specifications. Failure to use an independent power supply of proper capacity can
result in a tripped breaker, blown fuse, damage to existing wiring, or component failure. This
could lead to heat generation or fire.
• To prevent personal injury, a minimum of two people are required to lift the unit.
• Before moving the unit, secure the door shut with tape to prevent door from swinging open
while being moved. Carefully move unit to installation site and place in front of opening.
• If unit has been laid on its back or sides, place unit upright and allow a minimum of 24 hours
before connecting power.
ELECTRICAL SHOCK HAZARD ELECTRICAL SHOCK HAZARD
Disconnect power before installing or servicing appliance. Failure to do so can
result in death or electrical shock.
ELECTRICAL GROUNDING ELECTRICAL GROUNDING
THIS ICE MACHINE MUST BE GROUNDED. This ice machine is equipped with a NEMA 5-15
three-prong grounding plug
into a properly grounded, independent 3-prong wall outlet. If the outlet is a 2-prong outlet, it is
your personal responsibility to have a qualified electrician replace it with a properly grounded,
independent 3-prong wall outlet. Do not remove the ground prong from the power cord and do not
use an adapter plug.
• DO NOT ground to a gas pipe.
• Do not use an extension cord.
• To reduce the risk of electric shock, make sure the control switch is in the "OFF" position before
plugging in or unplugging the ice machine.
• To reduce the risk of electric shock, do not touch the control switch or plug with damp hands.
• Do not use an ice machine with a damaged power cord. The power cord should not be altered,
jerked, bundled, weighed down, pinched, or tangled. Such actions could result in electric shock
or fire. To unplug the ice machine, be sure to pull the plug, not the cord, and do not jerk the cord.
4
©2021 Hestan Commercial Corporation
to reduce the risk of potential shock hazards. It must be plugged