Outside Antenna Installation - Wilson Electronics PRO Serie Guide D'installation

Selecting a Location for the Outside Antenna
Cell Tower
The outside antenna must be mounted at a location outside of the home or building, where the
strongest cell signal is present. This can be accomplished by using the Wilson Signal Meter.
Alternatively, a cell phone in test mode can be used for finding the area around the building
with the strongest signal.
Mount the outside antenna as high as possible facing towards the suspected location of the
cell tower and pointing away from the expected location of the inside antenna(s).

Outside Antenna Installation

The antenna should be mounted as shown in Figure 1. The mounting bracket, included with
antenna, is adjustable and will accommodate pipe diameters from 1.25 inches to 2 inches
(pipe sold separately #901117). Mount the antenna so that there is at least 3 feet of clearance
in all directions around it. Make sure the antenna is not pointing across your own roof or at
the inside antenna as this will cause the cell site protection circuitry to shut down the signal
booster.
CORRECT INSTALLATION
Point antennas away from each other
Inside
Antenna
Signal Booster
Figure 1
5
Contact Wilson Electronics Customer Support Team with any questions at
Outdoor
Antenna
866-294-1660 or email: tech@wilsonelectronics.com
Wide Band Antenna
INCORRECT INSTALLATION
Never point antennas toward each other
Inside
Antenna
Signal Booster
Figure 2
Outdoor
Antenna