Wilson Electronics PRO Serie Guide D'installation page 3

3. Connect the cable from the outside antenna to the signal booster's "outside antenna"
connector. Refer to page 6 for more information on running cable. Lightning Surge
Protection is recommended for all in-building installations. Refer to pages 3 & 6.
4. Select a location for the inside antenna. Try to choose a position in the center of the area
needing improved signal. Keep in mind that proper inside antenna to outside antenna
isolation is necessary for the system to function properly. This may require as much as
50 to 75 feet of horizontal separation from the outside antenna. Vertical separation
also helps increase isolation. Alternate means of isolation are possible. If physical
separation is not possible, please contact Wilson Electronics Tech Support at 866-839-
9361 for suggestions on alternate methods to achieve isolation.
5. Connect the cable from the inside antenna to the signal booster's "inside antenna"
connector. Refer to page 6 for more information on running cable. Keep cable runs as
short as possible to reduce signal loss in the system.
6. Before powering up the signal booster, verify that both the outside antenna and the
inside antenna are connected correctly, and check that all connections are tight. Note:
Be careful when plugging the connectors in so as not to bend the center pins on the
connectors.
7. Power on the signal booster by plugging in the included power supply. If the lights are
not green, please refer to pages 9-11.
Multiple Kit Options Available
To purchase Expansion Kits call Wilson Electronics Sales Department at: 888-503-5329
460127 Kit
Wide Band Directional
Pro 70 Plus
Antenna 75' RG11
460227 Kit
Wide Band Directional B
Pro 70 Plus P 70 Pl
Antenna 75' RG11
Contact Wilson Electronics Customer Support Team with any questions at
Wide Band Panel Antenna
50' RG11
d Di ti l 4G D 4G Dome Ceiling Antenna C ili
50' RG11
866-294-1660 or email: tech@wilsonelectronics.com
Note: Kits may contain diff erent accessories
2' RG11
Power Supply
2' RG11
A
Power Supply
Lightning Surge
AC/DC
Protector
12V/3A
Lightning Surge
AC/DC
Protector
12V/3A
2