15 PRELIMINARY OPERATIONS
15.1 PELLET LOADING
The fi rst operation to perform before switching the
stove on is to fi ll the fuel (pellet) tank using the
relevant scoop.
Be careful not to touch the hot parts if fuel refi lling
is carried out with the stove running.
Do not empty the bag directly into the tank to
avoid loading sawdust or other foreign elements
that could compromise correct functioning of the
stove and to avoid dispersing the pellets outside
the tank itself.
Be sure to close the lid of the tank well after loading
the pellets. The safety pressure switch (for models
with outside air intake) verifi es proper closure (fi g.
3.1) and sends an alarm if the lid is left open for
more than 20 seconds with the stove running.
15.2 ELECTRICAL POWER SUPPLY
Connect the stove to the mains power, operate the
ON switch on the back of the stove, positioning it
to "I" (fi g. 3.2). If the connection is properly made,
the display will light up.
During long periods of non-use, it is recommended
to position the switch on the back of the machine
to OFF (O).
Do not touch the control panel when the stove is
being powered.
15.3 IGNITION
Before each ignition, make sure that the burn pot
is completely empty and correctly positioned in its
seat.
To turn on the stove hold the
few seconds.
Avoid manually turning on the stove if the automatic
ignition system is compromised.
During initial ignition of the stove it is possible to
generate unpleasant smells or fumes caused by
the evaporation or drying of some of the materials
used. This phenomenon will gradually disappear.
During the fi rst lightings, we recommend that you
keep the premises well ventilated.
Do not pour pellets directly into the burn pot.
Stoves in the "Hermetic" series:
Each time the fi rebox door and pellet tank
door is opened, avoid leaving it open for long
periods to prevent the closure sensor from
notifying the open door status with an acoustic
alarm.
15.4 POWER OFF
To turn off the stove hold the
few seconds.
24
key pressed for a
key pressed for a
10/2021 - EN
ATTENTION: Do not insert fuel through the
aeration outlets.
- 3.2 -
- 3.1 -