Installation; Mounting Position - CitrinSolar CS-EUV Manuel

CS-EUV
Components
No Designation Material
1 Housing CW617N
2 Screw M5X10 DIN965 Zn steel
3 Valve flap CW617N
4 O ring 8,73 × 1,78 FKM green
5 O ring 11,6 × 2,4 EPDM
6 O ring 23,3 × 2,4 EPDM
7 O ring 27 × 2,5 EPDM
8 Indicator plate EL zinc
9 Base plate GD-ZN Al4 Cu1
10 Distance piece M6x15,7 Zn steel
11 Screw 2,9 × 6,5 DIN 7981 Zn steel
12 Insert PPS
2

Installation

The installation of the valve must be carried out corre-
sponding to the approved technical regulations. Ensure
excess sealing material, tape etc does not enter the valve
body. In order to avoid blocking of the valve ball, the follow-
ing advice has to be considered and all solder, brazing or
welding processes near the valve are to be avoided.

2.1 Mounting position

The valve can be mounted in any position, but not with
the actuator to the bottom. In order to use the manual
operation +/- 90°, a cable loop of approx. 25 cm has to
be arranged during the electrical connection. In order to
have enough space to carry out maintenance work, keep
a distance of at least 100 mm from the wall or the device
respectively.
CitrinSolar GmbH Energie- u. Umwelttechnik • Böhmerwaldstr. 32 • D-85368 Moosburg • Tel.:+49 (0) 8761/33400 • Fax: +49 (0) 8761/334040
Page 12/48
Quantity
1
4
1
1
2
1
1
1
1
2
2
1
Important note
In order to attain the maximum operating safety
and reliability, it is recommended to flush the sys-
tem and to insert an appropriate strainer (0,65
µm) in front of each valve.
Mounting and demounting of valve and actuator