Lionelo Babyline SMART Manuel De L'utilisateur page 10

the wall with the use of screws or adhesive tape (fig. 2).
How to install with screws
1.
Mark the spot on the wall in which you wish to drill holes for
rawlplugs (fig. 3).
2.
Make a hole with a tool suitable for the specific surface and then
put rawlplugs in (fig. 4).
3.
Fix the assembly bracket by screwing screws in (fig. 5).
4.
Place the camera on the wall and position for the best angle of view.
Troubleshooting
Problem/question
The camera is not visible
in the application.
The camera is still in
the list of devices in the
application after resetting.
How to change Wi-Fi
network which the camera
is connected to?
The camera cannot
identify microSD card.
EN
Possible solution
Check Wi-Fi signal strength or place
the camera near the router while
configuring. Reset the camera and
add it again.
Resetting changes camera settings
only. The camera must also be deleted
in the application.
Delete the camera from the list of
devices in the application, and then
configure it again by connecting to
other network.
It is advisable to insert microSD card
when the camera is off. Make sure the
card is available and comes in FAT32
format and its maximum capacity is
128 GB. Check Internet connection.
‑ 10 ‑