Electrolux ERF3867SOW Notice D'utilisation page 40

40 www.electrolux.com
3. Insert the filter in the slot found in the
back of the air lever flap.
4. Close the air lever flap.
8.9 Starting the water system for
the first time.
Ensure proper connection to the water
supply, refer to "Connecting the water
hose".
1. Open the tap on the water
connection.
2. Start the refrigerator.
The water system main valve opens and
the pump starts to fill the system.
Water from final inspection
testing may be resident in the
appliance. Dispense and
discard at least 2 litres of
plain water and 1 litre of
carbonated water prior to
use.
8.10 Installation of the water
filter.
1. Unpack the filter.
2. Remove the accessories in front of the
water module and open the service
hatch.
3. Place a cloth or a piece of kitchen
towel in the space beneath the water
filter.
4. Pull the bypass cartridge outwards,
grasping the lower part, until the water
bypass cartridge is automatically
ejected.
5. Remove the protective wrapping of
the new water filter and insert the new
filter firmly into the filter connection.
6. Push the water filter back to its original
position.
7. Remove cloth or towel and make sure
that spilled water is wiped off.
8. Close the hatch and remount the
interior.
9. Keep the bypass cartridge for future
use.
10. Select Still cold water and dispense
about 2 litres of water. There may be
some air to start with.
1
8.11 Installation of the gas
cylinder.
If the gas cylinder is already
installed, remove the
transport support and turn
the lever upwards. Refer to
point 3.
1. Remove the gas cylinder wrapping
and screw on the adapter to the gas
cylinder. Tighten by hand only.
2