Electrolux ERF3867SOW Notice D'utilisation page 36

36 www.electrolux.com
Problem
There is too much carbon
dioxide in the water.
No carbon dioxide.
No or very low water flow.
Only gas comes out when
dispensing carbonated wa-
ter.
Dispensing is interrupted af-
ter a short time.
The "Water circuit cleaning"
and "Still cold water" indica-
tors are shown.
The buzzer sounds. The
"Alarm" icon and "Extra Hu-
midity" icons are flashing.
The water filter indicator
flashes.
The water filter indicator
lights constantly.
The temperature in the ap-
pliance is too low/too high.
Possible cause
Dilute with ordinary water. Refer to "Selecting and dis-
The gas cylinder is empty. Refer to "Replacing gas cylin-
The gas cylinder is empty. Refer to "Replacing gas cylin-
Sediment in the water.
Water supply obstructed.
Sediment in the water.
The maximum time of two
minutes is exceeded.
No water has been dis-
pensed in 10 days.
Failed water supplies.
Dispensing water more
than 2 minutes.
The filter has been totally
consumed.
20% of filter capacity re-
mains.
The temperature regulator
is not set correctly.
The door is not closed
correctly.
Solution
Dilute with ordinary water.
(See "The functions of the
water dispenser" in "Control
Panel"" chapter).
pensing water".
der".
der".
Remove and clean the strain-
er in the inlet hose connec-
tion.
Check water supply.
Remove and clean the strain-
er in the inlet hose connec-
tion.
Start new dispensing.
Dispense water in total 2 mi-
nutes and the icons goes off.
"Press any button to reset the
alarm. Select still cold water
and push the water dispens-
ing lever and release. The wa-
ter pump start and filling the
water system. After a few mi-
nutes the icons goes off.
Release the water dispensing
lever and press any button to
reset the alarm. Start new
dispensing.
Refer to "Replacing the water
filter".
Buy a new filter.
Set a higher/lower tempera-
ture.
Refer to "Closing the door".