Télécharger Imprimer la page

Bestway SPLASH-IN-SHADE Notice D'utilisation page 5

Piscine de jeu

Publicité

Les langues disponibles

Les langues disponibles

Assembly usually takes approximately 20 minutes.
Components list:
SIZE
A
8 ft. x 20 in.
(2.44 m x 51 cm)
Top Rail
SIZE
B
8 ft. x 20 in.
(2.44 m x 51 cm)
Vertical Pool Leg
SIZE
C
8 ft. x 20 in.
(2.44 m x 51 cm)
T-connector
SIZE
D
8 ft. x 20 in.
(2.44 m x 51 cm)
Pin
SIZE
E
8 ft. x 20 in.
(2.44 m x 51 cm)
Footing
F
M
Sprayer + Hose + Adaptor
SIZE
ITEM#
8 ft. x 20 in.
#256002001070
(2.44 m x 51 cm)
SIZE
G
8 ft. x 20 in.
(2.44 m x 51 cm)
Drain Valve Cap
SIZE
H
8 ft. x 20 in.
(2.44 m x 51 cm)
Hose Adaptor
SIZE
I
8 ft. x 20 in.
(2.44 m x 51 cm)
Stopper
SIZE
J
8 ft. x 20 in.
(2.44 m x 51 cm)
Liner
ITEM#
PART CODE
#256002001070
P61077ASS16
ITEM#
PART CODE
#256002001070
P61078ASS16
ITEM#
PART CODE
#256002001070
P6994ASS16
ITEM#
PART CODE
#256002001070
P61020ASS16
ITEM#
PART CODE
#256002001070
P6996ASS16
N
PART CODE
QTY
P61619ASS17
1
ITEM#
PART CODE
#256002001070
P6H1158ASS16
ITEM#
PART CODE
#256002001070
P6H1420ASS16
ITEM#
PART CODE
#256002001070
P6C1418ASS19
ITEM#
PART CODE
#256002001070
P04414
K
QTY
8
Tent leg
L
QTY
8
Fiberglass pole
O
QTY
8
Tent's outer cloth
P
QTY
18
Pin Gasket
Drawings may not reflect actual product, not scaled to size. Please see FAQ for additional information.
CHOOSE THE CORRECT LOCATION
IMPORTANT:
The pool must be set up on a completely flat and level surface. Please do not install the pool if the
surface is Inclined or sloped.
QTY
Correct conditions to set up the pool:
• The selected location has to be capable of uniformly supporting the weight for the entire time the pool is installed,
moreover the location must be flat and must be cleared of all objects and debris including stones and twigs.
8
• We recommend positioning the pool away from any objects kids could use to climb into the pool.
NOTE:
Position the pool near an adequate drainage system to deal with overflow or to discharge the pool.
NOTE:
Position the pool near an AC power outlet protected by a GFCI-(Ground Fault Circuit Interrupter).
Incorrect conditions to set up the pool:
• On uneven ground the pool may collapse causing serious personal injury and/or damage to personal property and will
void the warranty and prevent any service claims.
• Sand should not be used to create a level base; the ground must be dug out if necessary.
• Directly under overhead power lines or trees. Be sure the location does not contain underground utility pipes, lines or
cables of any kind.
• Do not set up the pool on driveways, decks, platforms, gravel or asphalt surfaces. The selected location should be firm
enough to withstand the pressure of the water; mud, sand, soft / loose soil or tar are not suitable.
• Grass or other vegetation under the pool will die and may cause odors and slime to develop, therefore we recommend
removing all grass from the selected pool location.
• Avoid areas prone to aggressive plant and weed species that may grow through the ground cloth or liner.
NOTE:
Check with your local city council for by-laws relating to fencing, barriers, lighting and safety requirements and
ensure you comply with all laws.
NOTE:
If have a filter pump, refer to the pump's manual for instructions.
NOTE:
The ladder must match the pool size and should to be used only for entering and exiting the pool. It is
forbidden to exceed the permitted payload of the ladder. Check regularly if the ladder is properly assembled.
Installation
Fig. 1
QTY
1
Fig. 3
QTY
1
Fig. 5
QTY
3
Fig. 7
QTY
1
5
SIZE
ITEM#
8 ft. x 20 in.
#256002001070
(2.44 m x 51 cm)
SIZE
ITEM#
8 ft. x 20 in.
#256002001070
(2.44 m x 51 cm)
SIZE
ITEM#
8 ft. x 20 in.
#256002001070
(2.44 m x 51 cm)
SIZE
ITEM#
8 ft. x 20 in.
#256002001070
(2.44 m x 51 cm)
Fig. 2
Fig. 4
Fig. 6
Fig. 8
PART CODE
QTY
P61079ASS16
8
PART CODE
QTY
P61080ASS16
8
PART CODE
QTY
P61809ASS17
1
PART CODE
QTY
P04429
18

Publicité

loading