Speck pumps Badu Jet Smart 1,6 kW Instructions De Montage Et Notice D'utilisation page 34

Fitting of the jet housing in polyester pools
Press knob gasket (26) into jet housing (1) and place against
the back of the pool wall.
Fix the jet housing from the front with ten self-tapping screws
(52) through clamping ring (28) and clamping ring gasket (27) to
the pool wall.
Attention:
ATTENTION:
The jet housing is made of ABS. If the suction and pressure
tubes are to be glued into the housing when the housing
is already in place, a minimum hardening time of 12 hours
must be observed.
34
Tighten the self-tapping screws only by hand.
Do not use force.
07.03.2014 TB-b bta badu jet smart_engl.indd