LENCO SCD-580SI Guide D'utilisation page 10

Play mode
Repeat single track
Repeat single folder
Repeat all tracks
Random mode
Off mode
 Repeat play
Repeat play can repeat one single track or whole disc.
 Random play
Random Play will play the content in random order.
CD programming
Up to 20 tracks can be programmed for disc play in any order. Before use, be sure to press the Stop
1. Set in CD mode & stop the CD playback.
2. Press the "Mem/Clk-Adj" button (4) and MEMORY will appear on LCD display (6).
3. Select a desired track by pressing Tune
4. Press the "Mem/Clk-Adj" button (4) to store the track into memory.
5. Repeat steps 3 and 4 to add additional tracks if necessary.
6. When all the desired tracks have been programmed, press Play/Pause
programmed order.
7. Press Stop button (7) to stop playback, press Stop button again to clear all programmed tracks.
 The programming mode will automatically stop if no button is being pressed in a period of about 10 seconds
after pressing the Mem/Clk-Adj (4) button.
Playback of MP3 songs from USB memory stick
The system is able to decode and playback MP3 music files stored on a USB memory stick.
1. Press the Function button (13) until the display shows "USB".
2. Plug-in the USB pen-drive and make sure it is inserted correctly.
 NOTE: Connecting the USB memory stick in the wrong way can damage the audio system or your USB
memory stick. Please check before inserting it into the USB port of the audio device
3. The audio system will read the content of the USB media and starts playback automatically. The LCD display (6)
will show the track number and playback time.
4. Playback functions are the same as MP3 cd mentioned earlier.
Indicator
on LCD display
& flashing
ALL
RAN
-----------
or Tune button (17).
10
button (8) to play the disc in the
button (7).