LENCO SCD-580SI Guide D'utilisation page 7

 Do not cover any vents and make sure that there is a space of several centimeters around the unit for
ventilation.
Connection
1. Connect the DC plug of the included AC/DC adaptor to DC jack (21) then the AC/DC adaptor connect to the
AC outlet.
2. When you first plug the unit into the mains, the unit will go into standby mode.
Press the On/Standby button (2) to turn on the unit. The LCD display will lighten up and show the welcome text,
indicating that the unit is ready for use.
DC connection
For DC operation, open the battery compartment and insert 8 size C/UM-2 batteries. When using batteries,
unplug the AC cable from the AC socket.
Setting the clock
1. Set unit in standby mode.
2. Press the "Mem/Clk-Adj" button (4) once, display will show "SET CLOCK"
3. Then press the "Mem/Clk-Adj" button (4) again and the display will flash "24HR" press the Tune Up
Tune Down button (17) to select the clock format between 12 or 24Hour. Then press the "Mem/Clk-Adj"
button (4).
4. The first digit (hours) of "0:00" is flashing on the LCD display (6). Press Tune Up
button (17) to set the correct hour. Press "Mem/Clk-Adj" button (4) to store the correct hour.
5. The third & fourth digit (minutes) "00" is flashing, press the Tune Up
set the correct minutes. Then press "Mem/Clk-Adj" button (4) to store the correct minute.
 The clock setting mode will automatically quit if no button is within 5 seconds after pressing the
"Mem/Clk-Adj" button.
 If you press the on/off (2) while setting the time, the time setting mode will quit and no time settings will
be stored.
Listening to radio
Manual tuning
1. Press the On/Standby button (2) to Switch on the unit. Then press Function button (13) to select "Tuner"
mode.
2. Tune to the required station by pressing the Tuning Up or Down button (17).
3. Press the Volume button (16) to the desired volume level.
Auto tuning
1. Press Function button (13) to select "Tuner" mode.
2. Press and hold the Tuning Up or Down button (17) for 2-3 seconds and then release.
3. The unit will start seeking automatically and stop until a radio station is reached.
4. Repeat step 2 & 3 until the desired radio station is being reached.
5. Press Volume button (16) to the desired volume level.
7
or Tune Down
or Tune Down button (17) to
or