FMS TOYOTA LC80 LAND CRUISER Manuel D'utilisation page 5

LED Indicator
1. R.LED： The red power indicator;
2. G.LED： The green status indicator;
3. Car battery: Two colors light for battery volume display (hereinafter referred to as D3)
• When the power is high, the D3 green keeps on
• When the power is medium, the D3 yellow keeps on
• When the power is low, the D3 red keeps on
• When the power is off, the D3 red slow flash
• When the receiver drops the code, the tow-colors light is off
Binding
The transmitter and receiver have already been bound at the factory.
However if the receiver needs to be replaced or additional receivers bound follow these steps:
1. Turn on the transmitter while holding the bind button to enter bind mode. G.LED will start flashing quickly.
• Once in bind mode release the bind button.
2. The receiver will power on and wait for 1 second ,if without connection, it will enter the matching code
automatically;
3. Once binding is successful the receiver's LED will keep on.
Note: When binding, put the transmitter into bind mode first, then the receiver.
Stick Calibration
This function is used to set the neutral position for throttle and wheel.
Every transmitter is calibrated before leaving the factory, however if recalibration is required,please follow
these steps:
1. Turn and hold the wheel as far clockwise as it will turn, hold the throttle all the way forward, then turn on the
transmitter in calibration mode.
• The R.LED and G.LED will flash twice.
• Car Battery the D3 yellow keeps on
2. Calibrate wheel: Turn the wheel completely clockwise, then completely counterclockwise.
• When calibration is completed the R.LED will be off.
• Car Battery the D3 red keeps on
3. Trigger calibration: Pull the trigger back then forward as far as it will go.
• When calibration is completed the G.LED will be off.
• Car Battery the D3 Green keeps on
4.Both Wheel and rigger are Calibration passed
• the two-colors light is of
5. Once calibration is complete press the bind key to save and exit.
EN
04