Indexa DF15A Set Mode D'emploi page 26

18. Trouble shooting
Fault
Message"NO SIGNAL"
Unstable wireless reception
Monitor picture switches of automatically
In scan mode certain camera signals are not shown
Flickering picture
Picture is too bright
recording not possible
26 - GB
Cause
Incorrect channel selected
Camera not powered
The camera and monitor are not paired
The camera is out of range
Objects are preventing wireless connection
Antennas are not parallel to each other
Camera channel not activated
Monitor and camera too far apart
Antennas not parallel
Wireless connection is blocked
Interference with wireless signal
Battery is discharged
Power safe mode is selected
Camera channel has not been selected or have no connection
Strong lightsource shining into the camera lens
Overexposure due to strong light source
SD-card not inserted
SD-card locked
SD-card full
Remedy
Select correct channel by pressing button [12]
Check that the Power LED [20] on the corresponding camera lights. If
not, check the mains adapter and cable connection.
Pair camera and monitor
Reduce the distance between camera and receiver
Remove large objects or change the location of camera and/or receiver
Position antennas parallel to each other
Activate the desired camera channel (see Chapter 12.2)
Reduce the distance between camera and monitor
Position antennas parallel to each other
Remove objects, in particular metallic objects and/or change the location
of camera and/or monitor
Check that there are no interference sources near camera and receiver eg
WLAN Router, elektrical produvts, Microwave ovens
Connect mains adapter
Press any button or turn off the Power safe mode (s. section 12.4)
Refer to chapter 12.2
Move the camera to another location
Change the direction or location of the camera
insert an unlocked, formatted SD-card
unlock the SD-card
format the SD-card (see chapter 12.9)
Indexa GmbH, Paul-Böhringer-Str. 3, 74229 Oedheim, Germany
www.pentatech.de