Brandson Equipment 303579 Mode D'emploi page 9

4. Initial use
Check that the product and the components are intact and that the device is work-
ing properly when using it for the first time Take the device out of the package and
remove all the packaging material. Place the lamp on a flat and even surface, so
that it does not fall over. Remove the battery safeguard on the rear of the lamp by
turning the battery compartment anticlockwise and removing the plastic washer
between the battery and the contact. Then close the battery compartment prop-
erly again.
Then insert the supplied DC coaxial power connector into a properly installed pow-
er socket and connect it to the lamp in order to start using it.
You can switch the lamp on or off by touching "ON/OFF" on the front.
Touch the "Mode" button on the front to select one of the three light modes (nat-
ural, white and yellow light). To adjust the brightness of the lamp, touch the "In-
crease" or "Decrease" button (with the lamp switched on) until you obtain the
desired brightness.
You can charge your mobile phone, for example, using the USB port on the back
of the device.
5. Display functions
First, set the current time and the current date. To do this, press the "SET
" button on the back of the lamp. The time starts flashing. Set the desired time
using the "UP" and "DOWN " buttons. Confirm your entry using the "SET
" button. The setting sequence is as follows: Hour -> Minutes -> Year -> Month ->
Day.
Press the "UP " button to change between the 12-hour and 24-hour display.
Press the "DOWN " button to change between °C and °F.
Press the "Backlight " button repeatedly to select the display backlight or to
switch it on or off.
9
English