To Use The Blender Accessory - Menuett 007845 Instructions D'utilisation

Caution! Do not operate the product for more than
90 seconds at a time. Let the product become cool for 2
minutes before you operate it again.
Caution! Do not operate the product for more than 3
work cycles of 90 seconds. Let the product become cool for
30 minutes before you operate it again.
9
Turn the control knob to the off position "0".
10
Disconnect the power plug from the power outlet.
11
Remove the bowl lid.
Warning! Do not remove the bowl lid when parts
move. Wait until all parts have stopped before you remove
the bowl lid.
12
Remove the disc accessory holder.
13
Remove the disc accessory from the disc accessory
holder.
Warning! The disc accessories have sharp edges. Do
not touch the sharp edges.
14
Turn the bowl counter-clockwise and remove it from
the base unit.
15
Remove the food from the bowl.
16
Clean the base unit and the accessories. Refer to "4.1
To clean the base unit" on page 42 and "4.2 To
clean the accessories" on page 42.

3.7 To use the blender accessory

Use the blender accessory to make smoothies or similar
types of food.
Caution! Do not use the blender accessory to prepare
meat.
Caution! Do not use hot water with the blender
accessory.
1
Put the product on a level and stable surface.
2
Install the blade drive unit (A) to the blender
container (B). (Figure 7)
41
3
Put the blender container on the base unit (C) and
turn it clockwise until it is locked in position.
Note! The product will not start if the bowl is not locked in
position.
4
Put the blender lid (D) on the blender container.
5
Put your prepared food items into the blender
container through the hole in the blender lid. If
applicable, also add water to the blender container to
make the product operate more smoothly.
Caution! Do not put food items larger than 15 x 15 x 15
mm in the blender container.
Caution! Food items and water must not exceed the
"MAX" marking on the blender container.
6
Align the tabs on the measuring cup (E) with the hole
in the blender lid.
7
Put the measuring cup in the hole in the blender lid
and turn it 90° clockwise to lock it in position.
Note! To remove the measuring cup, turn it 90°
counter-clockwise and lift it.
8
Connect the power plug to an earthed power outlet.
Warning! Make sure that the blender lid is fully
attached before you start to operate the product.
9
Turn the control knob to the required speed or use
the pulse function. Operate the product until the
required consistency is obtained. Refer to "To use the
control knob".
Warning! Do not remove the blender lid when parts
move. Wait until all parts have stopped before you remove
the blender lid.
Caution! Do not operate the product for more than 3
minutes at a time with the blender accessory.
10
Turn the control knob to the off position "0".
11
Disconnect the power plug from the power outlet.
12
Turn the blender container counter-clockwise and
remove it from the base unit.
2022_001