Publicité
Les langues disponibles
Les langues disponibles
HOW TO USE
1.
Remove sprayer cap (Fig.1).
2.
Fill tank with tap water to either 2 minute or 4 minute water fill line (Fig. 2).
3.
Screw on and secure sprayer cap (Fig. 3).
4.
Place spray bottle on the base and plug the base in (Fig. 4).
5.
Press power button (Fig. 5).
6.
Press desired ozone generation time button (2 minutes or 4 minutes) (Fig. 6).
7.
Light ring and tank will illuminate green while ozone generation is in
process and water will begin to bubble (Fig. 7).
8.
Light ring will illuminate blue when ozone generation is complete.
9.
Remove spray bottle from base.
10. Spray surface and object to clean, sanitize, and deodorize.
•
Spray surface until thoroughly wet and allow ozonated water to sit for 30
seconds. Surface should remain visibly wet during this 30-second period.
•
For best results, spray within 30 minutes of ozone generation.
•
Allow ozonated water to sit on surface or object for 30 seconds to kill up
to 99.9% of bacteria and viruses.
•
Allow ozonated water to sit on surface or object for 1 minute to kill up to
99.999% of bacteria and viruses.
•
Only tap water should be used in this product. It will not function
properly with distilled or purified water.
EN
Fig. 1
Fig. . 5
Fig. 2
Fig. 6
6
Fig. 3
Fig. 7
Fig. 4
Publicité
