Special Functions, Watching Tv; Troubleshooting - Comfort audio Comfort Contego T900 Mode D'emploi

Special functions
Add a receiver / more receivers
If you want to use more than one receiver to listen with this is not
a problem (e.g. during a guided tour.) In order to add a receiver go
into the menu on the extra receiver, Choose Pair. Then go into the
menu of the transmitter. Choose Pair and press OK. Pair complete!
The new receiver can then be used to listen with.
Tip: - More than one receiver can be paired at the same time.
- Instead of using the transmitter menu you can pair by
pushing two quick times on the menu button on the
transmitter.
Watching TV
In order to be able to hear the TV or other sources of sound you can
use the sound kit. You can then listen with the receiver.
Connect the cable (A) between the TV and
the socket on the Contego transmitter
A
(T900). (Make sure the transmitter is set on
"Line in")
With the help of the built in microphone in
the receiver you can also listen to people
sitting next to you on the sofa.
24
Talking on the phone
In order to hear better when you are talking on the
phone, use the Comfort Contego Telephone kit and
connect it to your landline telephone and the transmitter.
See separate User manual for further instructions.

Troubleshooting

Transmitter and receiver do not start.
Charge the transmitter and the receiver. Remember that you must
hold the ON/OFF button in for 2 seconds in order to start Comfort
Contego. If it still does not work - check the charger is connected to
the mains. Contact your retailer to change the battery.
Poor speech reception
The distance between the transmitter and the receiver is too long.
The distance between the microphone and the person speaking can
also be too long.
Poor range and interference
In certain environments consisting of concrete, iron and metal
plates, the range can be reduced. There can also be interfering
equipment nearby. Change channel.
If you change channel on the transmitter the receiver must be on
and within the transmitters range to follow the channel switch.
NOTE
If you use a hearing aid make sure that it is working and that it is
in the T-coil setting. Always make sure that the receiver and the
transmitter are paired.
R800
2
T800
R800
T800
25