Cequent Performance Products 45509 Mode D'emploi page 3

Always wear SAFETY GLASSES
when installing hitch
NOTE;
WITH THIS HITCH INSTALLED
THE STEP BUMPER IS NO LONGER ABLE
TO BE USED AS A TOWING POINT.
EXISTING
M14 BOLTS
⑨④
2010 MODEL
EXISTING
BUMPER
CORNER
BRACE
BUMPER
ATTACHMENT
(NOT REQUIRED ON 03-09)
⑩
2010 – CURRENT
CENTER BUMPER
MODEL
ATTACHMENT
ATTACHMENT
EXISTING M14 HANDLE NUT (03-09 MODEL)
M14 FLANGED NUT (2010 MODEL)
©2016 Cequent™ Performance Products, Inc. - Printed in Mexico
Installation Instructions
PART NUMBERS: 45509, 45709, CQT45509
Must have pick-up chassis
Spring mount (as shown
above the frame).
Bumper
BED ATTACHMENT
HOLE
#3
#4
③④
VIBRATION DAMPENER
(ON CERTAIN MODELS ONLY)
TOP HOLE – BUMPER
Figure 1
ATTACHMENT
LONG BED
FRAME
⑤
⑥
④
⑦
DRILL ONE HOLE
②①
2003-09 MODEL
ATTACHMENT
Sheet 3 of 12
Fastener Kit: 45509F
① Qty. (4) Hex nut M14x2.00
② Qty. (4) Conical washer 5/8''
③ Qty. (6) Hex nut M12x1.75
④ Qty. (14) Conical washer 1/2''
⑤ Qty. (4) Carriage bolt
1/2''-13x1.75, GR8
⑥ Qty. (2) Block .250x3.50x1.50
⑦ Qty. (4) Hex nut 1/2''-13,GR2
⑧ Qty. (2) Pull wire 1/2''
⑨ Qty. (4) Bolt M12
1.75x45mm, CL 10.9
⑩ Qty. (3) Block .50x1.50x5.75
SHORT BED
FRAME
DRILL 2
HOLES
03-09 MODEL
EXISTING
Conical washer
BUMPER
teeth side
CORNER
BRACE
against hitch
EXISTING
M12 BOLTS
45509N 05-25-16 Rev. A